AQUIFER CHARACTERISTICS IN UYO METROPOLIS: A CASE STUDY OF ITIAM ETOI, ANUA OFFOT AND IBOKO OFFOT | Blazingprojects Postgraduate Thesis
Home / Civil engineering / AQUIFER CHARACTERISTICS IN UYO METROPOLIS: A CASE STUDY OF ITIAM ETOI, ANUA OFFOT AND IBOKO OFFOT

AQUIFER CHARACTERISTICS IN UYO METROPOLIS: A CASE STUDY OF ITIAM ETOI, ANUA OFFOT AND IBOKO OFFOT

 

Table Of Contents


  • Cover Page…       …     …     …     …     …     …     …     …     iTitle Page…         …     …     …     …     …     …     …     …     …     iiDeclaration…       …     …     …     …     …     …     …     …     iiiCertification…     …     …     …     …     …     …     …     …     ivDedication…       …     …     …     …     …     …     …     …     vAcknowledgements…   …     …     …     …     …     …     …     viAbstract… …     …     …     …     …     …     …     …     …     viiTable of Contents…     …     …     …     …     …     …     …     viii  

Chapter ONE

INTRODUCTION

  • 1.1          Background of the Study…     ….     …     …     …     …    
  • 11.2          Statement of the Problem…   ….     …     …     …     …    
  • 31.3          Objectives of the Study…       ….     …     …     …     …    
  • 31.4    Significance of the Research…         ….     …     …     …     …    
  • 31.5    Scope of the Study…     ….     …     …     …     …     …    
  • 41.6    The Study Area…         ….     …     …     …     …     …     …     4CHAPTER TWO: LITERATURE REVIEW2.1     Determination of Aquifer…   ….     …     …     …     …     82.
  • 1.1Indirect Methods of Aquifer Location…     …     …     …     92.
  • 1.2Direct Method of Aquifer Location…         …     …     …     …    
  • 102.2    Hydro-stratigraphic Units…   ….     …     …     …     …    
  • 112.3    Groundwater Storage and Aquifer Characteristics…   …     142.
  • 3.1Micro Properties…       ….     …     …     …     …     …     152.
  • 3.2Macro Properties…       ….     …     …     …     …     …    
  • 162.4    Types of Water Bearing Formation…       ….     …     …     …    
  • 172.5    Types of Aquifer…       ….     …     …     …     …     …     182.
  • 5.1An Unconfirmed Aquifer…     ….     …     …     …     …     192.5.
  • 1.1Perched Water Table…         ….     …     …     …     …     …     202.
  • 5.2Confined Aquifer…       ….     …     …     …     …     …    
  • 202.6    Aquifer Test…     ….     …     …     …     …     …     …     21 

Chapter THREE

SYSTEM DESIGN AND IMPLEMENTATION

  • MATERIAL AND METHODS3.0     Materials… ….     …     …     …     …     …     …     …    
  • 243.1    Data Collection… ….     …     …     …     …     …     …    
  • 243.2    Pumping Test Methodology…         ….     …     …     …     …     25CHAPTER FOUR: RESULT AND DISCUSSION4.1           Physico-chemical and Bacteriological Analysis ofBorehole water Sample…       ….     …     …     …     …    
  • 284.2    Borehole 1 Data Analysis (Itiam Etoi) …   ….     …     …     294.
  • 2.1Specific Capacity (q) … ….     …     …     …     …     …     304.
  • 2.2Transmissivity… ….     …     …     …     …     …     …     304.
  • 2.3Coefficient of Storages…       ….     …     …     …     …     …     31    
  • 4.3    Borehole 2 Data Analysis (Iboko Offot) …         ….     …     …     314.
  • 3.1Specific Capacity (q) … ….     …     …     …     …     …     314.
  • 3.2Transmissivity (T) …   ….     …     …     …     …     …     314.
  • 3.3Coefficient of Storage… ….     …     …     …     …     …    
  • 324.4    Borehole 3 Data Analysis (Anua Offot)… …     …     …     324.
  • 4.1Pumping Test Analysis…       ….     …     …     …     …     324.
  • 4.2Specific Capacity…       ….     …     …     …     …     …     324.
  • 4.3Transmissivity… ….     …     …     …     …     …     …     344.
  • 4.4Coefficient of Storage… ….     …     …     …     …     …     34CHAPTER FIVE: SUMMARY, CONCLUSION AND          RECOMMENDATIONS5.1     Summary…         ….     …     …     …     …     …     …     …    
  • 345.2    Conclusion…       ….     …     …     …     …     …     …     345.
  • 2.1Borehole No.1… ….     …     …     …     …     …     …     355.
  • 2.2Borehole No.2… ….     …     …     …     …     …     …     355.
  • 2.3Borehole No.3… ….     …     …     …     …     …     …    
  • 355.3    Recommendations…     ….     …     …     …     …     …     37          REFERENCES…         …     …     …     …     …     …     39

Thesis Abstract

The description and location of the geologic formations and water bearing zones within the study area are discussed. The geologic aquifers in the area are the upper, medium and lower sands. Pumping test and soil sample data were obtained from Itiam Etoi, Iboko Offot and Anua Offot. The analysis reveals that the following aquifer characteristics such as storativity, transmissivity, yield and specific yield lie within the acceptable limit. Water quality analysis results indicate that boreholes have acceptable water quality. The following aquifer and well characteristics were obtained, specific capacity (q) 28.27 – 2.8.8m2/h/m, Transmissivity (T) 217.58 – 23784.88m2/day, Discharge/Yield 6123.1 – 7517.8m2/day, Drawdown 8.91m – 10.88m. The drawdown values of 24hrs of pumping reveals a good entrance velocity of water into the borehole and high storativity and transmissivity of the aquifer. The geologic formation has good water-bearing formation with medium sand being predominant. Generally, the aquifer in the study area is permeable and of high storage capacity.

Thesis Overview

INTRODUCTION1.4            Background of the StudyThe earth crust which is also referred to as lithosphere comprises of consolidated materials such as granite, diamond, sandstone and unconsolidated materials like sand, gravel, pebbles and boulders. The zone of the rock fracture which is the outer part of the earth’s crusts is porous to a certain degree. Subsurface geologic materials such as gravel and sand have openings between individual particles. There are also crevices, joint or fractures in hard rocks, solution channels, and caverns in limestone. These properties facilitate flow through these materials.Geologic formation can be classified according to their ability to allow flow through their voids and subsequently transmit water from one point to another. A geologic formation which contains water and transmits it from one point to another in quantities sufficient to supply wells is called an aquifer. Moreover, groundwater is stored in the space and fracture within geologic materials such as soil, sand, gravel, pebbles, boulders and even sandstone with defined crevices, joints and rock that lie beneath the land surface. Aquifer is the geologic layer that is filled with water and that can transmit enough water to supply a well under normal hydraulic gradients. These materials have voids and can contain and transmit water from one point to another. When these materials called aquifers are found, below the water table, that is, in the zone of saturation, they act as reservoirs and conducts by holding and transmitting water from one point to another.On average, 7000 million litres (ML) of water are abstracted from zone of these aquifers each day. Approximately, 50% of this vast amount of water comes from cretaceous chalk aquifer, 35% from Triassic sandstones and the remainder from smaller aquifers, the most important of these being Jurassic limestone.The aquifer as a water bearing formation has the function of storage and transmission. It stores water as reservoir and transmits it as a pipeline. This is because the voids or pore spaces between particles in the water bearing formation serve both as storage spaces and network of conduits. The ground water is constantly moving slowly over extensive areas from recharge region to discharge area. The aquifer material detains large quantities of water in transit and can supply a well drilled to intercept flow.Ground water storage within the aquifer can only be viable for water extraction, and the estimated volume of water discharged per unit time from the ground water is limited by the aquifer characteristics in Uyo metropolis.1.5            Statement of the ProblemSince aquifer is the only geological formation that stores and transmit enough water at any given time and quantity hence there is need to examine and analyse its characteristics within the metropolis.The determination of areas of potentially productive wells in Uyo metropolis will be difficult to identify.The location of borehole within aquiclude and aquifuge always proves abortive hence this study will help minimize this incident.1.6            Objectives of the StudyThis research is aimed at:a.       determining and analyzing the aquifer characteristics in some locations in Uyo metropolis with respect to: Storativity, Transmissivity and Specific Yield.b.       pump testing to determine the performance characteristics of the boreholes and he aquifer characteristics namely; the transmissivity, specific capacity and the storativity in Uyo metropolis.c.       Recommendations for improvement where necessary. 1.4     Significance of the Research·       The outcome of the work will serve as a reference for future work on aquifer characteristics in Uyo metropolis.

Blazingprojects Mobile App

📚 Over 50,000 Research Thesis
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Thesis-to-Journal Publication
🎓 Undergraduate/Postgraduate Thesis
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Criminology. 4 min read

Evaluating AI-Powered Predictive Policing Effectiveness and Ethical Implications...

This research focuses on understanding how effective AI-powered predictive policing is in preventing crimes and whether it raises ethical concerns. Predictive p...

BP
Blazingprojects
Read more →
Communication and li. 2 min read

Developing an AI-Powered System for Dialect Recognition and Preservation...

This research focuses on creating an artificial intelligence (AI) system that can recognize different dialects of a language and help preserve them. Dialects ar...

BP
Blazingprojects
Read more →
Art and Design. 3 min read

Augmented Reality for Enhancing Engagement in Public Art Installations...

This research focuses on using augmented reality (AR) technology to make public art installations more engaging and interactive for viewers. Public art, such as...

BP
Blazingprojects
Read more →
Applied science. 2 min read

Smart Waste Management System Using IoT Sensor Networks...

This research focuses on developing a smart waste management system that uses Internet of Things (IoT) sensor networks to improve how waste is collected and man...

BP
Blazingprojects
Read more →
Agriculture and fore. 2 min read

Development of AI-Driven Pest Detection System Using Drone Imagery...

This research aims to develop a system that can automatically detect pests in crops or forests using images captured by drones combined with artificial intellig...

BP
Blazingprojects
Read more →
Agricultural science. 3 min read

Developing an E-learning Platform to Enhance Agricultural Science Education Engageme...

This research focuses on creating an online learning platform designed specifically for agricultural science education. The goal is to make learning more engagi...

BP
Blazingprojects
Read more →
Adult education. 3 min read

Assessing the Impact of Mobile Learning Applications on Adult Educational Attainment...

This research explores how mobile learning applications influence the educational progress of adults. With the widespread use of smartphones and tablets, many a...

BP
Blazingprojects
Read more →
Zoology. 3 min read

Developing AI-Powered Acoustic Monitoring for Wildlife Population Estimation...

This research focuses on creating a new way to monitor wildlife populations using artificial intelligence (AI) and sound recordings. Traditionally, counting ani...

BP
Blazingprojects
Read more →
Veterinary Medicine. 2 min read

Development of an AI-based Disease Diagnostic Tool for Livestock Health Monitoring...

This research focuses on developing a computer-based system that uses artificial intelligence (AI) to diagnose diseases in livestock quickly and accurately. Liv...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us