Automatic pump control with water level monitor and digital display

• List of table Table 5.1:    Result Analysis Table 5.2:    Bill of Engineering measurement and EvaluationList of figures Fig 3.1:        Schematic diagram Fig 3.2:        Battery symbol Fig 3.3:        Bilateral switch CMOS IC Fig 3.4:        Seven segment display system Fig .5:        Forward and reverse bias of diodes with its        equivalent Fig 3.6:        Switch symbol Fig 3.7:        Symbol of Resistor Fig 3.1:        Schematic Resistor Fig 4.1:        Block Diagram of water level controller Fig 5.1:        Representing result analysis in histogram Fig 5.2:        Input voltage wave form Fig 5.3:        Output voltage wave  TABLE OF CONTENTSTitle page Certification page Dedication Acknowledgement Abstract List of tables/figures Table of contentsCHAPTER ONE: INTRODUCTION Thesis LayoutCHAPTER TWO: LITERATURE REVIEW

Chapter THREE

RESEARCH METHODOLOGY

• MATERIALS AND METHODS
• 3.1   Materials
• 3.2   Methods

Chapter FOUR

DATA PRESENTATION AND ANALYSIS

•  SYSTEM OPERATION
• 4.1   The power supply unit
• 4.2   The control unit
• 4.3   The sensory unit
• 4.4   The display unit
• 4.5   The pump-motor unit

Chapter FIVE

SUMMARY, CONCLUSION AND RECOMMENDATIONS

• RESULT ANALYSIS AND DISCUSSIONS
• 5.1   Water level
• 5.2   Connection test
• 5.3   Continuity est
• 5.4   Signal generation
• 5.5   Workability test CHAPTER SIX: CONCLUSION AND RECOMMENDATIONS
• 6.1   Conclusion
• 6.2   Recommendation
• 6.3   Problems encountered REFERENCES