TABLE 1  – Experimental determination of pressure for printing
11- Effect of temperature on sharpness of print.
111 ” Description of (components) parts and materials use for them
1v- comparison of cost and properties of materials
LIST OF FIGURES
Description
Figure 1 sketch of alternative A
Figure 2. Sketch of alternative B.
Figure 3 sketch of alternative C
Figure 4 isomeric view of hot plate square housing
Figure 5 isometric view of type holder
Figure 6 &7 load and free body diagram of crank are (Handle) and rod.
LIST OF SYMBOLS
A ” Area
A ” Acceleration
D ” Maximum shaft diameter
d- minimum  shaft diameter
e- efficiency
k ” Thermal conductivity
c ” Heat capacity
x ” The pressure transmissibility of lever system (press x  1/duration )
t ” Time
l ” Length of shaft
m ” Mass
m ” Maximum bearding moment
p – Electric power
q ” Quantity of heat
TABLE OF CONTENTS
Title page ii
Letter of transmittal iii
Release iv
Approval page v
Dedication vi
Acknowledgement vii
Abstract viii
List of figures ix
 List of tables x
List of symbols xi
Table of contents xii

Chapter ONE

1.1 introduction 1
1.2 literature review and data collection 2
1.3 experimental determination of pressure for prating 3
1.4 design specification 9

Chapter TWO

2.1 Design solutions 11
2.2 Alternative A press foot printer 11
2.3 Alternative  B; crank arm  (handle ) 14
2.4 Alternative  C; automatic (motorized) printer 17
2.5 Comparison of alternative and choice 20

Chapter THREE

3.1 Design selection and analysis of parts of chosen alternative 22
3.2 Theory of  design/  design calculation 24
3.3 The  design of the shaft (Hollow) 26

Chapter FOUR

4.1 construction of prototype 28
4.2 general 28
4.3 material selection 29
4.4 sequence of construction and assembly 40

Chapter FIVE

5.1 Testing of prototype (test ” run) 40
5.2 Evaluation of machine efficiency 40
5.3 Operator’s manual 41
5.4 Costing  (cost analysis) 42
5.5 Problems Encounter 45
5.6 Conclusion 45
5.7 Recommendation 46
REFERENCES